Our Tips for Cleaning Bathroom Seals

o keep tile joints in your nickel bathroom, you need daily cleaning. However, for lack of time, it is possible that one zaps completely this gesture when one does the cleaning. As a result, the joint may become moldy, yellowed or blackened at worst. So how do you keep your little bathroom on top?

Cleaning Bathroom Seals

One rule is to clean the joints of his bathroom, we use good cleaning products. Who says shock cleaners do not necessarily say luxury products. Attention, we can overcome his expectations with the house tips.

Use his closet

As said before, home products can be used to overcome the blackened, yellowed or moldy seal. So, do not worry, just open your closet and find our timeless cleaning products. These products are:

  • Baking soda ;
  • White vinegar and dishwashing liquid;
  • Ammonia.

For the cleaning itself, you will need:

  • Some water ;
  • A sponge ;
  • A toothbrush that is no longer used or will only be used for cleaning!

Baking soda and white vinegar

You like to clean, but sometimes you forget to take care of your bathroom joints. No worries, take out your packet of baking soda and your bottle of white vinegar. After a month of neglected maintenance, you can catch up with the mixture of baking soda and white vinegar.

To do this, simply mix four tablespoons of baking soda in ten centiliters of white vinegar. Pour the mixture into a spray bottle. Close the cap well and lather a little. Then you only have to spray the mixture on the joints. Wait twenty-four hours before rubbing and rinsing.

White vinegar and dishwashing liquid

This tip is suitable for bathroom joints that have not been serviced for a maximum of three months. To make this cleaner, mix a glass of vinegar with a glass of dishwashing liquid. As the product is soft and not likely to discolor the tiles, you can use it on faience.

The cleaning will be done by simply sprinkling the parts to be cleaned with water to start. Then apply the mixture over the entire tile surface with a sponge. After that, scrub the joints of the tiles, bathtub and faucet with a toothbrush. To finish, rinse.

Ammonia

Ammonia is a little more potent than the previous mixture. Put goggles on a mouth mask and dish gloves when you use it. In addition, you will not dilute the product this time. So, to clean the joints of the shower tiles with ammonia, soak a sponge with the liquid. Then rub the joints with the sponge. Finally, rinse thoroughly with tap water. This cleaning technique is good for joints that have not been serviced for six months. It is very effective against molds and fungi of all kinds.

Clean with a suitable product

You can also clean your bathroom seals with a special cleaning product. Indeed, you can take for example the cleaning spray KF Sani-Joint Lifthofin . This product is bottled in a five hundred milliliter vaporizer.

This Lifthonin brand shower cleaner eliminates mold and algae. It will rid you of unpleasant black marks on the joints and sanitary devices of the shower. This product is even suitable for silicone bath seals.

Attention, it will be necessary to put gloves when using this cleaner. In addition, rinse well after cleaning.

In which case change his bathroom seal?

At some point, you’ll have to think about changing the joints in your bathroom. This rule applies in particular to silicone gaskets. After three to five years, you have to replace the silicone gaskets. However, if you take good care of it, you will only have to change your joints after six or eight years.

Then, it will change the silicone seal when it becomes black mold and impossible to resurface. To replace the silicone seals, you just have to follow the advice of using your product. If you have some doubts, you can always seek the help of a professional. However, rest assured, the installation of the silicone seal is quite easy and does not require great DIY skills

Leave a Reply

Your email address will not be published. Required fields are marked *